Products

0.5THV Series Vector Target Adapter

0.5THV Series Vector Target Adapter

Use two target points to define a line

The 0.5THV Series creates a vector by using two target locations, precisely on the centerline of the adapter. Using most any software, it is easy to locate the point on the centerline of the shank which lies on the surface of the object being measured. This adapter may be used to create vector lines to evaluate "remote" target points (e.g., a critical point downrange on a hinge line). It is also handy when you suspect that the target hole may not be drilled square to the surface.

Note: If you don’t see the exact dimensions for your needs, please contact us.

Value ‘A’ = Low Offset
Value ‘B’ = High Offset
Value ‘C’ = Shank Diameter

Note 1: Minimum value for A (low offset) is 0.3125″ (8 mm).
Note 2: Maximum value for B (high offset) is 2.875″ (73 mm). Not all high offsets are compatible with all low offsets, check with us if you have a question. Minimum seat spacing (B-A) must be greater than 0.512" (13 mm).
Note 3: Minimum shank diameter is 0.100″ (3 mm). Maximum shank diameter is 0.750″ (19 mm).